Subaru LEGACY 2006 Manual page 3295

asieps_tobira.book 69 ページ ２００９年１０月２６日 月曜日 午前９時１６分
26.Extension Case
A: REMOVAL
1) Remove the transmission assembly.
<Ref. to 4AT-35, REMOVAL, Automatic Transmis-
sion Assembly.>
2) Remove the rear vehicle speed sensor.
(A) Rear vehicle speed sensor
3) Separate the transmission case and extension
case section.
Extension Case
(A)
AT-02207
AT-00118
4AT-69
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Apply vaseline to the contact surface, and attach
the selected thrust needle bearing to the end sur-
face of the reduction drive gear.
NOTE:
Install the thrust needle bearing in the correct direc-
tion.
2) Install a new gasket.
3) Install the extension case to transmission case.
4) Tighten bolts to secure the extension case.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
5) Install the rear vehicle speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
(A)
(A) Rear vehicle speed sensor
6) Install the transmission assembly.
<Ref. to 4AT-38, INSTALLATION, Automatic
Transmission Assembly.>
AT-00118
AT-02207