Subaru LEGACY 2006 Manual page 4170

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6. Subaru Select Monitor
A: OPERATION
CAUTION:
When the Subaru Select Monitor is communi-
cating (except when displaying the data), the
ABS warning light flashes and VDC warning
light illuminates in the combination meter. Do
not communicate with the Subaru Select Moni-
tor while driving, because the ABS and VDC
functions are disabled. Carefully drive the vehi-
cle, when you have to communicate with the
Subaru Select Monitor. When the data is dis-
played by the {Current Data Display & Save}
menu, both the ABS and VDC warning lights are
turned off and ABS and VDC functions are en-
abled.
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit. <Ref. to
VDC(diag)-10, SPECIAL TOOL, PREPARATION
TOOL, General Description.>
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Insert the cartridge to the Subaru Select Monitor.
<Ref. to VDC(diag)-10, SPECIAL TOOL, PREPA-
RATION TOOL, General Description.>
Subaru Select Monitor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
4) Connect the Subaru Select Monitor to the data
link connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's
side).
(1)
(1) Data link connector
(2) Connect the diagnosis cable to the data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
5) Turn the ignition switch to ON (engine OFF) and
turn the Subaru Select Monitor switch to ON.
ABS00111
(1) Power switch
6) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Brake Control} and press the
[YES] key.
8) Press the [YES] key after the {VDC AWD AT} is
displayed.
ABS00112
VDC(diag)-17
ABS00465
(1)
ABS00114