Subaru LEGACY 2006 Manual page 3968

asieps_tobira.book 7 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Use SUBARU genuine grease etc. or equivalent.
Do not mix grease etc. of different grades or man-
ufacturers.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply grease onto sliding or revolving surfaces
before installation.
• Before installing snap rings, apply sufficient
amount of grease to avoid damage and deforma-
tion.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plates,
or waste cloth between the part and the vise.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
(A)
ST-925091000
ST-926470000
General Description
TOOL NUMBER DESCRIPTION
925091000 BAND TIGHTENING
TOOL
(B)
926470000 AXLE SHAFT
PULLER
DS-7
DRIVE SHAFT SYSTEM
REMARKS
Used for tightening the boot band.
(A) Jig for the band
(B) Ratchet wrench
• Used for removing the axle shaft.
• Used with AXLE SHAFT PULLER PLATE
(28099PA110).