Subaru LEGACY 2006 Manual page 3391

asieps_tobira.book 39 ページ ２００９年１０月２６日 月曜日 午前９時１６分
14) Replace the front differential side retainer oil
seal.
(1) Remove the oil seal by using flat tip screw-
driver etc.
(2) Install a new oil seal using ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
• Apply oil to the oil seal lips.
• Be sure to replace the differential side oil seal af-
ter the procedure of removing front drive shaft from
transmission.
15) Apply grease to the oil seal lips.
16) Set the ST to side retainer.
ST 28399SA000 OIL SEAL PROTECTOR
ST
17) Install the front drive shaft into the transmis-
sion.
NOTE:
Replace the circlip of drive shaft with a new part.
18) Install the front drive shaft into transmission, re-
move the ST and insert the drive shaft securely.
ST 28399SA000 OIL SEAL PROTECTOR
Automatic Transmission Assembly
19) Install the inlet and outlet hoses to the ATF inlet
and outlet pipes.
20) Insert the ball joint into housing. <Ref. to FS-15,
INSTALLATION, Front Ball Joint.>
21) Install the front stabilizer bracket. <Ref. to FS-
14, INSTALLATION, Front Stabilizer.>
22) Install the clutch housing cover securing bolts.
AT-01378
AT-00110
23) Install the front cross support plate. <Ref. to
FS-13, INSTALLATION, Front Crossmember Sup-
port Plate.>
24) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
25) Install the shift select cable. <Ref. to CS-25, IN-
STALLATION, Select Cable.>
5AT-39
AUTOMATIC TRANSMISSION
AT-01390
AT-01373
AT-01374