Subaru LEGACY 2006 Manual page 3654

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CLUTCH SYSTEM
7. Clutch Pipe and Hose
A: REMOVAL
1) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake
Chamber.>
2) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-12, REMOVAL, Intercooler.>
3) Drain the clutch fluid. <Ref. to CL-21, Clutch Flu-
id.>
4) Disconnect the clutch pipe from the clutch hose
and master cylinder.
5) Pull out the clamp, then remove the clutch hose
from the bracket.
(B)
(A) Clamp
(B) Clutch hose
6) Disconnect the hose from the operating cylinder.
7) Remove the bracket.
Clutch Pipe and Hose
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed air from the clutch fluid. <Ref. to CL-22,
Clutch Fluid Air Bleeding.>
Tightening torque:
(A)
CL-00057
C: INSPECTION
Check pipes and hoses for cracks, breakage or
damage. Check joints for fluid leakage. If any
cracks, breakage, damage or leakage is found, re-
pair or replace the defective pipe or hose.
CL-20
T1: 15 N·m (1.5 kgf-m, 10.8 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T3: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
T1
T1
(A)
T3 (B)
(C)
(C)
T2
(A) Clutch pipe
(B) Clip
(C) Clutch hose
CL-00344