Subaru LEGACY 2006 Manual page 3727

asieps_tobira.book 53 ページ ２００９年１０月２６日 月曜日 午前９時１６分
D: ASSEMBLY
1) When the sleeve & hub assemblies have been
disassembled, reassemble by aligning the align-
ment marks.
NOTE:
Position the open ends of the spring 120° apart.
(A)
(B)
(C)
(D)
(A) 3rd-4th hub ASSY
(B) 3rd gear side
(C) 5th-Rev hub ASSY
(D) 5th gear side
2) Install the 3rd drive gear, outer baulk ring, syn-
chro cone, inner baulk ring, sleeve and hub assem-
bly for the 3rd needle bearing, on the transmission
main shaft.
(D)
(A)
(B) (C)
(A) 3rd needle bearing
(B) 3rd drive gear
(C) Inner baulk ring
(D) Synchro cone
(E) Outer baulk ring
(F) Sleeve & hub ASSY
Main Shaft Assembly for Single-range
MT-00191
(E)
(F)
MT-00200
5MT-53
MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
Align the groove in baulk ring with the shifting in-
sert.
3) Install the 4th needle bearing race onto trans-
mission main shaft using ST1, ST2 and press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
ST2
(A)
ST1
(A) 4th needle bearing race
4) Install the baulk ring, needle bearing, 4th drive
gear and 4th gear thrust washer to the transmission
main shaft.
NOTE:
Align the baulk ring and gear & hub assembly with
the key groove.
(B)
(A) Groove
(B) 4th gear side
MT-00192
(A)
MT-01407