Subaru LEGACY 2006 Manual page 3677

asieps_tobira.book 14 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CLUTCH SYSTEM
4. Release Bearing and Lever
A: REMOVAL
1) Remove the transmission assembly from vehicle
body.
<Ref. to 5MT-24, REMOVAL, Manual Transmis-
sion Assembly.>
2) Remove the two clips from the clutch release le-
ver and remove the release bearing.
CAUTION:
Be careful not to deform the clips.
3) Remove the dust cover.
( A )
( B )
(A) Clutch release lever
(B) Dust cover
4) Remove the lever spring from the pivot with a
screwdriver by accessing it through the clutch
housing release lever hole. Then remove the re-
lease lever.
( B )
(A) Clutch release lever
(B) Screwdriver
Release Bearing and Lever
B: INSTALLATION
NOTE:
Before or during installation, lubricate the following
points with a light coat of grease.
• Contact surface of lever and pivot
• Contact surface of lever and bearing
• Transmission main shaft spline (Use grease con-
taining molybdenum disulphide.)
1) While pushing the release lever to the pivot and
twisting it to both sides, fit the lever spring onto the
raised portion of the pivot.
NOTE:
• Apply
003603001) to the contact point of the release lever
and operating cylinder.
• Observing from the main case hole, check that
the lever spring is installed securely.
CL-00023
2) Install the release bearing and fasten it with two
clips.
3) Install the dust cover.
( A )
CL-00024
4) Check the bearing for smooth movement by op-
erating the release lever.
5) Install the transmission assembly.
<Ref. to 5MT-26, INSTALLATION, Manual Trans-
mission Assembly.>
CL-14
grease (KOPR-KOTE:
( A )
(A) Release lever
( A )
( B )
(A) Release lever
(B) Dust cover
Part No.
CL-00026
CL-00023