asieps_tobira.book 30 ページ 2009年10月26日 月曜日 午前9時16分
MANUAL TRANSMISSION AND DIFFERENTIAL
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the rear crossmember.
Tightening torque:
T1: 75 N·m (7.6 kgf-m, 55 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front exhaust pipe. (Non-turbo model)
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.>
6) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-9, INSTALLATION, Center
Exhaust Pipe.>
7) Install the rear exhaust pipe and muffler.
8) Lower the vehicle.
9) Connect the ground cable to battery.
C: INSPECTION
Perform the following inspection procedures and
repair or replace faulty parts.
1. PITCHING STOPPER
Check the pitching stopper for bends or damage.
Check that the rubber is not stiff, cracked or other-
wise damaged.
2. CROSSMEMBER AND CUSHION RUB-
BER
Check crossmember for bends or damage. Check
that the cushion rubber is not stiff, cracked, or oth-
erwise damaged.
Transmission Mounting System
T 1
T 2
MT-00081
5MT-30