Subaru LEGACY 2006 Manual page 3792

asieps_tobira.book 46 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1) Cover the reverse check sleeve with a rag, and
remove the snap ring using a screwdriver.
NOTE:
Replace the snap ring with a new part if it is de-
formed or spring force is weakened.
(A) Snap ring
2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Use new O-rings.
• Be careful not to damage the adjusting shim be-
tween reverse check sleeve assembly and the
case.
Reverse Check Sleeve
(A)
MT-00153
(E)
(G)
MT-00154
5MT-46
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, check cam, return spring
(5th-Rev) and reverse check spring to the reverse
check sleeve.
NOTE:
Be sure to position the bent section of reverse
check spring to fit in the groove of the check cam.
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
2) Hook the curved section of the reverse check
spring over the reverse check plate.
3) Rotate the cam so that the protrusion of the re-
verse check cam comes to the opening of the plate.
4) With cam held in that position, install the reverse
check plate onto the reverse check sleeve and hold
in place with the snap ring.
5) Position the O-ring in the groove of sleeve.
(E)
(G)
MT-00154