Subaru LEGACY 2006 Manual page 3294

asieps_tobira.book 56 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
3) Attach the magnet at the specified position of the
oil pan.
4) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
or equivalent
5) Fill the three holes aside from the bolt holes in
the transmission case, with liquid gasket.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
or equivalent
6) Install the oil pan by equally tightening the bolts.
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
Control Valve Strainer
7) Fill ATF from the oil charge pipe.
Recommended fluid:
<Ref. to 4AT-3, HYDRAULIC CONTROL AND
LUBRICATION, SPECIFICATION, General De-
scription.>
Capacity:
Fill with the same amount of ATF as drained.
8) Bleed the air of control valve. <Ref. to 4AT-60,
Air Bleeding of Control Valve.>
9) Check the ATF level. <Ref. to 4AT-26, Automat-
ic Transmission Fluid.>
AT-02743
C: INSPECTION
Check the control valve strainer for holes, damages
or adhesion of dust and other foreign particles.
AT-02742
AT-01339
4AT-56