Subaru LEGACY 2006 Manual page 3752

asieps_tobira.book 14 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• When disassembling the case and other light al-
loy parts, use a plastic hammer to force it apart. Do
not pry apart with screwdrivers or other tools.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Use SUBARU genuine gear oil, grease or the
equivalent. Do not mix fluid, grease, etc. of different
grades or manufacturers.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-399411700
ST-899524100
General Description
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply gear oil onto sliding or revolving surfaces
before installation.
• Replace deformed or damaged snap rings with
new parts.
• Before installing O-rings or oil seals, apply suffi-
cient amount of gear oil to avoid damage and defor-
mation.
• Be careful not to incorrectly install or fail to install
O-rings, snap rings and other such parts.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or cloth between the part and the vise.
• Avoid damaging the mating surface of the case.
• Before applying sealant, completely remove the
old sealant.
TOOL NUMBER DESCRIPTION
399411700 ACCENT BALL
INSTALLER
899524100 PULLER SET
5MT-14
REMARKS
Used for installing reverse shifter rail arm.
Used for removing and installing the roller bear-
ing (Differential).
(1) Puller
(2) Cap