Subaru LEGACY 2006 Manual page 3705

asieps_tobira.book 26 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
6) Insert the tip of inner cable into connector hole of
select lever, and fix the cable to bracket.
7) Shift the select lever to the "N" range, and then
adjust the select cable position. <Ref. to CS-27,
ADJUSTMENT, Select Cable.>
8) Install the heat shield cover.
9) Install the front, center and rear exhaust pipes,
and the muffler. (SOHC and DOHC non-turbo mod-
el)
• SOHC model
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-7, INSTALLA-
TION, Center Exhaust Pipe.> <Ref. to EX(H4SO)-
8, INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-10, INSTALLATION, Muffler.>
• DOHC 3.0 L model
<Ref. to EX(H6DO)-5, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H6DO)-7, INSTALLA-
TION, Rear Exhaust Pipe.> <Ref. to EX(H6DO)-9,
INSTALLATION, Muffler.>
10) Install the center, rear exhaust pipes and the
muffler. (DOHC turbo model)
<Ref. to EX(H4DOTC)-9, INSTALLATION, Center
Exhaust Pipe.> <Ref. to EX(H4DOTC)-12, IN-
STALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, INSTALLATION, Muffler.>
Select Cable
C: INSPECTION
Check the removed cable and replace or adjust if
damaged, rusty or malfunctioning.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and
cracks.
4) Check the boot for damage, cracks and deterio-
ration.
5) Move the select lever from "P" to "D" range.
Check the existence of feel to contact the detents in
each range. If the detents cannot be felt or the po-
CS-00535
sition pointer is improperly aligned, adjust the ca-
ble.
6) Check if the starter motor rotates when the se-
lect lever is set to "P" range.
7) Check the back-up light illumination when the
select lever is in "R" range.
8) Check the parking lock operation when the se-
lect lever is in "P" range.
AT-01331
CS-26