Subaru LEGACY 2006 Manual page 3403

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
10.SPORT Indicator Light Display
A: OPERATION
When any on-board diagnostics item is malfunctioning, the SPORT indicator light blinks from the time the
malfunction is detected after starting the engine until the ignition switch is turned OFF. The malfunctioning
part or unit can be determined by a DTC during the on-board diagnostics operation. Problems which oc-
curred previously can also be identified through the memory function. If the SPORT indicator light does not
show a problem (although a problem is occurring), the problem can be determined by checking the perfor-
mance characteristics of each sensor using Subaru Select Monitor. Warning light signal patterns are shown
in the figure.
(A)
(1)
(2)
(B)
(1)
(2)
(C)
(1)
(2)
(A) Ignition switch ON (engine OFF)
(1) ON
(2) OFF
Perform the inspection when the SPORT indicator light does not operate correctly.<Ref. to 4AT(diag)-21, IN-
SPECTION, SPORT Indicator Light Display.>
SPORT Indicator Light Display
(3)
(3)
(B) Normal (Engine ON)
(3) 2 seconds
(4) 0.25 seconds
4AT(diag)-20
(4)
(5)
(C) Faulty (Engine ON)
(5) Blink
AT-02980