Subaru LEGACY 2006 Manual page 4113

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Step
1 CHECK SUBARU SELECT MONITOR DATA.
1) Select {Current Data Display & Save} in the
Subaru Select Monitor.
2) Read the data of the "Tire pressure warning
light".
2 CHECK WIRING HARNESS.
Measure the resistance between tire pressure
monitoring control module and combination
meter connector.
Connector & terminal
(i11) No. 6 — (R211) No. 2:
3 CHECK POOR CONTACT IN CONNECTOR. Is there poor contact in the tire
Subaru Select Monitor
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS)
Check
Is "ON" indicated?
Is resistance less than 0.5 Ω? Go to step 3.
pressure monitoring control
module connector and combi-
nation meter connector?
TPM(diag)-15
Yes No
Replace the tire Go to step 2.
pressure monitor-
ing control module.
<Ref. to WT-11,
TIRE PRESSURE
MONITORING
CONTROL MOD-
ULE, REMOVAL,
Tire Pressure
Monitoring Sys-
tem.>
Repair the har-
ness and connec-
tor between tire
pressure monitor-
ing control module
and combination
meter.
Repair the con- Check the combi-
nector. nation meter.