Subaru LEGACY 2006 Manual page 3898

asieps_tobira.book 32 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
11) Draw out the pinion mate shaft and remove pin-
ion mate gears, side gears and thrust washers.
(Model without LSD)
NOTE:
The gears should be marked or kept separated
right and left, and front and rear as well as thrust
washers.
(A) Side gear
(B) Pinion mate gear
(C) Thrust washer
(D) Differential case
(E) Pinion mate shaft
12) Remove the self-locking nut while holding the
companion flange with ST.
ST 498427200 FLANGE WRENCH
13) Extract the companion flange with a puller.
Rear Differential (T-type)
DI-00238
ST
DI-00071
DI-00072
DI-32
14) Press the end of drive pinion shaft and extract it
together with rear bearing cone, pinion height ad-
justing washer and washer.
NOTE:
Hold the drive pinion so as not to drop it.
ST 398467700 DRIFT
15) Remove the rear bearing cone from drive pin-
ion by supporting the cone with ST.
NOTE:
Place the replacer so that its center-recessed side
faces the pinion gear.
ST 398517700 REPLACER
16) Remove the front oil seal from differential carri-
er using ST.
ST 398527700 PULLER ASSY
(A)
(A) Differential carrier
(B) Front oil seal
ST
DI-00073
ST
DI-00074
(B)
DI-00145