Subaru LEGACY 2006 Manual page 3275

asieps_tobira.book 122 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
36.Transmission Control Device
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 4AT-35, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
4AT-68, REMOVAL, Torque Converter Assembly.>
3) Remove the input shaft.
4) Lift-up the lever on the rear side of transmission
harness connector, and then remove it from the
stay.
5) Disconnect the air breather hose. <Ref. to 4AT-
66, REMOVAL, Air Breather Hose.>
6) Remove the inhibitor switch connector from the
stay.
7) Wrap vinyl tape around the nipple attached to
the air breather hose.
8) Remove the pitching stopper bracket.
9) Remove the inhibitor switch.
10) Remove the control valve body assembly.
<Ref. to 4AT-57, REMOVAL, Control Valve Body.>
11) Pull out the straight pin of manual plate.
Transmission Control Device
12) Remove the bolts securing select lever, and
then remove the select lever, manual plate and
parking rod.
NOTE:
Be careful not to damage the lips of press-fitted oil
seal in the case.
13) Remove the detention spring.
AT-00304
B: INSTALLATION
1) Install the detention spring to the transmission
case.
Tightening torque:
6 N·m (0.6 kgf-m, 4.3 ft-lb)
AT-02224
4AT-122
(A)
(C)
(B)
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
(D)
AT-02225
AT-00307
AT-00307