Subaru LEGACY 2006 Manual page 3370

asieps_tobira.book 100 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
21) Turn the transmission sideways.
22) Install the oil pump cover.
(1) Apply ATF to the O-ring of input clutch shaft.
(2) Install the oil pump cover to AT main case
while supporting the input clutch shaft and oil
pump housing with your hand.
(3) Make sure the rear end of drive pinion shaft
is engaged to the spline of reduction driven
gear.
(A)
(A) Drive pinion shaft
(4) Protect the input clutch shaft with a cloth,
and rotate to engage the spline of the input
clutch and rear carrier using pliers.
NOTE:
Work with pressing the oil pump cover.
(A)
(A) Cloth
AT Main Case
(5) Combine the oil pump cover with transmis-
sion main case.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
23) Install the center differential carrier. <Ref. to
AT-01990
5AT-74, INSTALLATION, Center Differential Carri-
er.>
24) Install the reduction driven gear. <Ref. to 5AT-
71, INSTALLATION, Reduction Driven Gear.>
25) Install the extension case. <Ref. to 5AT-65, IN-
STALLATION, Extension Case.>
26) Install the control valve body. <Ref. to 5AT-53,
INSTALLATION, Control Valve Body.>
27) Install the converter case assembly to the
transmission case assembly. <Ref. to 5AT-78, IN-
STALLATION, Converter Case.>
28) Install the air breather hose. <Ref. to 5AT-61,
INSTALLATION, Air Breather Hose.>
29) Install the ATF filter pipe. <Ref. to 5AT-55, IN-
AT-02092
STALLATION, ATF Filter.>
30) Install the oil charge pipe together with an O-
ring. <Ref. to 5AT-62, INSTALLATION, Oil Charge
Pipe.>
31) Install the torque converter assembly. <Ref. to
5AT-63, INSTALLATION, Torque Converter As-
sembly.>
32) Install the transmission assembly to the vehi-
cle. <Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
33) Perform Clear Memory 2 operation. <Ref. to
5AT(diag)-18, CLEAR MEMORY MODE, OPERA-
TION, Subaru Select Monitor.>
34) Perform the inspection with driving the vehicle
at the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from the transmission body, etc.
• Occurrence of noise caused by interference etc.
AT-02046
NOTE:
If excessive shift shock is felt, execute advance op-
eration of learning control. <Ref. to 5AT(diag)-22,
PROCEDURE, Learning Control.>
5AT-100
AT-01976