Subaru LEGACY 2006 Manual page 4089

asieps_tobira.book 12 ページ ２００９年１０月２６日 月曜日 午前９時１６分
REAR SUSPENSION
D: ASSEMBLY
1. FRONT BUSHING
1) Set the ST A with the larger side of its inner di-
ameter turned upward.
2) Set the rear arm with the vehicle inner side of
arm turned downward.
3) Place the bushing on rear arm as shown in the
figure.
4) Place the ST B on the bushing, and press-fit until
each edge surface of bushing and rear arm is
aligned.
ST-A 20099AE020INSTALLER & REMOVER
SET
ST-B 20099AE020INSTALLER & REMOVER
SET
(2)
(1)
ST-B
ST-A
(1) 0±5°
(2) Identification paint: Assemble with the identifi-
cation paint side facing the arm inner side.
Rear Arm
2. REAR BUSHING
1) Insert the bushing into the bore of ST D.
2) Set the ST C, ST D and bearing puller in the
specified positions as shown in the figure, and then
press-fit the bush until the outer end of bush and
rear end of rear arm is flat.
ST-C 20099AE040INSTALLER & REMOVER
ST-D 20099AE040INSTALLER & REMOVER
E: INSPECTION
Check the rear arm for bending, corrosion or dam-
age.
RS-00120
RS-12
SET
SET
ST-C
ST-D
RS-00056