Subaru LEGACY 2006 Manual page 3337

asieps_tobira.book 70 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
28.Rear Drive Shaft
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and then
remove the extension case. <Ref. to 5AT-65, RE-
MOVAL, Extension Case.>
3) Pull out the rear driveshaft from center differen-
tial assembly.
4) Remove the drive plate and driven plate.
B: INSTALLATION
1) Select the shim. <Ref. to 5AT-67, ADJUST-
MENT, Transfer Clutch.>
2) Install drive plate and driven plate.
3) Insert the rear driveshaft into the center differen-
tial assembly.
4) Combine the extension case, and then install the
rear vehicle speed sensor. <Ref. to 5AT-65, IN-
STALLATION, Extension Case.>
5) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1) Using a press, remove the revolution gear.
(A) Revolution gear
Rear Drive Shaft
2) Using a press, remove the front and rear side
ball bearings and clutch hub.
D: ASSEMBLY
Assemble in the reverse order of disassembly.
NOTE:
AT-03231
• Use new ball bearings and revolution gear.
• Make sure the clutch hub is facing the correct di-
rection.
(A)
E: INSPECTION
• Check each parts for holes, damages or other
foreign matters.
• Inspect the extension end play, and adjust it to
within the standard value. <Ref. to 5AT-67, AD-
JUSTMENT, Transfer Clutch.>
AT-00149
5AT-70
(B)
(A)
(C)
(A) Rear ball bearing
(B) Rear drive shaft
(C) Clutch hub
(B)
(A)
(D)
(A) Front side
(B) Clutch hub
(C) Rear side
(D) Revolution gear
AT-00151
(C)
AT-00152