Subaru LEGACY 2006 Manual page 3988

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
FRONT SUSPENSION
7. Front Strut
A: REMOVAL
1) Lift-up the vehicle, and then remove the front
wheels.
2) Place an alignment mark on the camber adjust-
ing bolt and strut.
3) Remove the bolt securing the brake hose from
the strut.
4) Remove the bolt securing the ABS wheel speed
sensor harness.
5) Remove the two bolts securing the housing to
the strut.
NOTE:
While holding the head of the adjusting bolt, loosen
the self-locking nut.
Front Strut
6) Remove the three nuts securing strut mount to
body.
FS-00037
B: INSTALLATION
1) Install the strut mount at the upper side of strut to
body, and tighten it with new self-locking nuts.
Tightening torque:
20 N·m (2.0 kgf-m, 14.5 ft-lb)
2) Align alignment marks on the camber adjusting
bolt and strut.
FS-00038
Using new self-locking nuts, install the strut to the
housing.
NOTE:
While holding the head of adjusting bolt, tighten the
self-locking nut.
Tightening torque:
152 N·m (15.5 kgf-m, 112.1 ft-lb)
3) Secure the ABS wheel speed sensor harness to
the strut.
Tightening torque:
33 N·m (3.4 kgf-m, 24.3 ft-lb)
4) Install the bolts which secure the brake hose to
the strut.
Tightening torque:
33 N·m (3.4 kgf-m, 24.3 ft-lb)
5) Install the front wheels.
NOTE:
Inspect the wheel alignment and adjust if neces-
sary.
FS-20
FS-00039