Subaru LEGACY 2006 Manual page 3706

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
D: ADJUSTMENT
1) Shift the select lever to "N" range.
2) Remove the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-10, REMOVAL, Muf-
fler.>
• DOHC turbo model
<Ref. to EX(H4DOTC)-12, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-13, REMOV-
AL, Muffler.>
• DOHC 3.0 L model
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
3) Remove the heat shield cover.
4) Loosen the adjusting nuts on both sides.
(A) Adjusting nut A
(B) Adjusting nut B
Select Cable
5) With the select lever pushed towards the rear of
the vehicle, turn the adjustment nut B until it just
contacts the connector. Then loosen the nut for 1/2
turn.
6) Set a spanner wrench to adjusting nut B so that
it does not rotate, and then tighten the adjusting nut
A.
AT-01331
Tightening torque:
( B ) ( A )
CS-00040
7) After the completion of adjustment, confirm that
the select lever operates normally at all ranges.
8) Install in the reverse order of removal.
CS-27
CONTROL SYSTEMS
(B)
(C)
(A)
(F)
(D)
(E)
(A) Forward side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
( B )
(A) Adjusting nut A
(B) Adjusting nut B
CS-00041
( A )
CS-00042