Subaru LEGACY 2006 Manual page 3267

asieps_tobira.book 118 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
8) Check the low clutch clearance.
(1) Place same thickness shims on both sides
to prevent plate from tilting.
(2) Check the clearance between retaining
plate and low clutch operation.
Initial standard:
0.7 — 1.1 mm (0.028 — 0.043 in)
Limit thickness:
1.6 mm (0.063 in)
(A)
(A) Thickness gauge
(B) Low clutch drum
If the clearance exceeds the service limits, re-
place the drive plate and select and adjust the
retaining plate to within default standard values.
Retaining plate
Part number
31567AB050
31567AB060
31567AB070
31567AB080
31567AB090
9) Install the washer to the rear internal gear.
(A)
(A) Rear internal gear
(B) Washer
AT Main Case
10) Install the rear internal gear.
11) Install the thrust needle bearing in the correct
direction.
(B)
AT-00283
Thickness mm (in)
3.8 (0.150)
4.0 (0.157)
4.2 (0.165)
4.4 (0.173)
12) Install the washer by aligning the protrusion of
4.6 (0.181)
the washer with the hole of the rear planetary carri-
er.
(B)
AT-00275
4AT-118
(A)
(A) Rear internal gear
(B) Low clutch drum
(A)
(B)
(A) Thrust needle bearing
(B) Low clutch drum
(C) Rear planetary, carrier side
(D) Low clutch piston side
(A)
(A) Washer
(B) Rear planetary carrier
(B)
AT-00276
(C)
(D)
AT-02222
(B)
AT-00278