Subaru LEGACY 2006 Manual page 4026

bp06usen601.fm 22 ページ ２０１０年５月２７日 木曜日 午後３時６分
POWER ASSISTED SYSTEM (POWER STEERING)
23) After adjusting toe-in and steering angle, tight-
en the lock nut on tie-rod end.
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
NOTE:
When adjusting toe-in, hold the boot as shown to
prevent it from being rotated or twisted. If it be-
comes twisted, straighten it.
C: DISASSEMBLY
1. RACK HOUSING ASSEMBLY
1) Disconnect the four pipes from gearbox.
NOTE:
Remove the pipes C and D, which are fixed to
clamp plate, as a unit.
2) Secure the gearbox removed from vehicle in a
vise using ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
CAUTION:
Secure the gearbox in a vise using ST as shown
in the figure. Do not secure the gearbox without
this ST.
(1) Clamp
3) Remove the tie-rod end and lock nut from gear-
box.
Steering Gearbox
PS-00051
(1)
ST1
ST2
PS-00492
PS-22
4) Remove the small clip from the boot using pliers,
and then move the boot to tie-rod end side.
(1) Clip
5) Using a flat tip screwdriver, remove the band
from boot.
NOTE:
Replace the boot if there is damage, cracks or de-
terioration.
(1) Band
6) Using the ST, loosen the lock nut.
ST 926230000 SPANNER
ST
(1)
(1) Lock nut
PS-00053
(1)
PS-00509
PS-00494