Subaru LEGACY 2006 Manual page 4072

asieps_tobira.book 8 ページ ２００９年１０月２６日 月曜日 午前９時１６分
PARKING BRAKE
9) Drive the vehicle to break-in the parking brake
lining.
(1) Drive the vehicle at about 35 km/h (22
MPH).
(2) With the parking brake release button
pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 m (0.12 mile)
in this condition.
(4) Wait 5 to 10 minutes for the parking brake to
cool down. Repeat again from step (1).
(5) After breaking-in, re-adjust the parking
brakes.
C: INSPECTION
1) Measure the brake disc rotor inside diameter. If the
disc is scored or worn, replace the brake disc rotor.
Disc rotor inside diameter:
Standard:
170 mm (6.69 in)
Service limit:
171 mm (6.73 in)
2) Measure the lining thickness. If it exceeds the
limit, replace shoe assembly.
Lining thickness:
Standard:
3.2 mm (0.126 in)
Service limit:
1.5 mm (0.059 in)
NOTE:
Replace the right and left brake shoe as a set.
D: ADJUSTMENT
1. SHOE CLEARANCE
1) Return the parking brake lever fully.
2) Remove the adjusting hole cover from the back
plate.
3) Turn the adjusting screw using a flat tip screw-
driver until the brake shoe is in close contact with
the disc rotor.
(2)
(1)
(4)
(1) Adjusting screw
(2) Adjusting hole cover (rubber)
(3) Flat tip screwdriver
(4) Back plate
Parking Brake Assembly (Rear Disc Brake)
(3)
PB-00032
PB-8
4) Turn back (downward) the adjusting screw 3 to 4
notches.
CAUTION:
Check there is no brake drag.
5) Install the adjusting hole cover to the back plate.
6) Adjust the parking lever stroke. <Ref. to PB-8,
LEVER STROKE, ADJUSTMENT, Parking Brake
Assembly (Rear Disc Brake).>
2. LEVER STROKE
1) Adjust the shoe clearance before adjusting lever
stroke. <Ref. to PB-8, SHOE CLEARANCE, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
2) Remove the parking lever cover.
3) Operate the parking brake lever 3 to 4 times.
4) Turn the adjusting nut until the lever stroke is at
the specified value.
Lever stroke:
5 to 6 notches when pulled with a force of 200
N (20.4 kgf, 45 lb)
(1) Adjusting nut (Self-locking nut)
5) Check there is no brake drag.
6) Install the parking lever cover.
(1)
PB-00054