Subaru LEGACY 2006 Manual page 3326

asieps_tobira.book 81 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5) Remove the front brake piston using com-
pressed air.
6) Remove the D-ring from front brake piston.
2. OIL PUMP
1) Take out the oil pump housing.
2) Take out the oil pump body.
Oil Pump Cover
D: ASSEMBLY
1. FRONT BRAKE
1) Apply ATF to D-ring, and then install it to the
front brake piston.
2) Install the front brake piston to oil pump cover.
NOTE:
Install by aligning the "
ton surface with the oil pump cover rib.
AT-02349
AT-01982
3) Install the retainer and return spring.
4) Install the front brake piston assembly using
ST1, ST2 and ST3.
ST1 18762AA000 COMPRESSOR SPECIAL
ST2 18765AA000 COMPRESSOR SUPPORT
ST3 18763AA000 COMPRESSOR SHAFT
ST2
5) Install the genuine driven plate instead of retain-
er plate, and temporarily assemble the drive plate
and driven plate.
Part No. 31536AA290Driven plate
5AT-81
AUTOMATIC TRANSMISSION
" mark on front brake pis-
AT-02350
TOOL
ST1
ST3
AT-01981