Subaru LEGACY 2006 Manual page 3871

asieps_tobira.book 52 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
9) Extract the bearing cone with ST1, ST2 and
ST3.
NOTE:
• Do not attempt to disassemble the parts unless
necessary.
• Never mix up the RH and LH bearing races and
cones.
ST1 498077000 REMOVER
ST2 399520105 SEAT
ST3 899864100 REMOVER
ST3
10) Remove the hypoid driven gear by loosening
hypoid driven gear bolts.
11) Remove the self-locking nut while holding the
companion flange with ST.
ST 498427200 FLANGE WRENCH
ST
Rear Differential (VA-type)
12) Extract the companion flange with a puller.
ST1
13) Removes the drive pinion shaft.
14) Remove the rear bearing cone from drive pin-
ion by supporting the cone with ST.
NOTE:
ST2
Place the replacer so that its center-recessed side
DI-00370
faces the pinion gear.
ST 398517700
DI-00371
15) Remove the front oil seal from differential carri-
er using screwdriver.
16) Remove the pilot bearing, front bearing cone
and collar.
DI-00372
DI-52
(A)
(B)
(A) Companion flange
(B) Puller
REPLACER
(D)
(B)
(C)
(A) Pilot bearing
(B) Collar
(C) Front bearing
(D) Rear bearing cup
DI-00394
ST
DI-00373
(A)
DI-00374