Subaru LEGACY 2006 Manual page 3279

asieps_tobira.book 35 ページ ２００９年１０月２６日 月曜日 午前９時１６分
9. Automatic Transmission
Assembly
A: REMOVAL
1) Set the vehicle on a lift.
2) Open the front hood and support with the hood
stay.
3) Disconnect the ground cable from the battery.
4) Remove the air intake duct.
<Ref. to IN(H4SO)-8, REMOVAL, Air Intake Duct.>
5) Remove the air intake chamber.
<Ref. to IN(H4SO)-7, REMOVAL, Air Intake Cham-
ber.>
6) Remove the air cleaner case stay.
7) Disconnect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
8) Remove the starter.
<Ref. to SC(H4SO)-6, REMOVAL, Starter.>
9) Remove the pitching stopper.
10) Separate the torque converter assembly from
the drive plate.
(1) Remove the V-belt covers.
Automatic Transmission Assembly
CAUTION:
Be careful not to drop bolts into the converter
case.
11) Attach the ST to the converter case.
ST 498277200
AT-01327
12) Remove the ATF level gauge.
NOTE:
Plug the opening to prevent entry of foreign parti-
cles into the transmission fluid.
AT-01328
13) Remove the throttle body. <Ref. to FU(H4SO)-
10, REMOVAL, Throttle Body.>
14) Disconnect the engine harness, then remove
the harness connector from the engine harness
bracket.
AT-01329
4AT-35
AUTOMATIC TRANSMISSION
(2) Remove the service hole plug.
(3) Remove the bolts which hold the torque
converter assembly to the drive plate.
(4) Place the wrench on the crank pulley bolt,
and remove all the bolts while rotating the crank
pulley a little bit at a time.
STOPPER SET
ST
AT-00102
AT-00804
AT-01330