Subaru LEGACY 2006 Manual page 3738

asieps_tobira.book 29 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from the battery.
2) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake
Chamber.>
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(H4SO)-5, REMOVAL, Air Cleaner
Case.>
4) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-12, REMOVAL, Intercooler.>
5) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground cable from the battery.
2) Lift-up the vehicle.
3) Remove the front exhaust pipe. (Non-turbo mod-
el) <Ref. to EX(H4SO)-8, REMOVAL, Rear Ex-
haust Pipe.>
4) Remove the center exhaust pipe. (Turbo mod-
el)<Ref. to EX(H4DOTC)-8, REMOVAL, Center
Exhaust Pipe.>
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Set the transmission jack under the transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
Transmission Mounting System
8) Remove the rear crossmember.
9) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
MT-00069
2) Install the air intake chamber and cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-6, INSTAL-
LATION, Air Cleaner Case.> <Ref. to IN(H4SO)-7,
INSTALLATION, Air Intake Chamber.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, INSTALLATION, Inter-
cooler.>
4) Connect the ground cable to battery.
5MT-29
MANUAL TRANSMISSION AND DIFFERENTIAL
T2
MT-00079
T1
MT-00085