Subaru LEGACY 2006 Manual page 3266

asieps_tobira.book 117 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2. PLANETARY GEAR AND LOW CLUTCH
1) Apply ATF to the D-ring, and then install it to the
low clutch piston.
2) Install the low clutch piston to low clutch drum.
(A) Low clutch piston
(B) Low clutch drum
3) Install the spring retainer to low clutch piston.
(A) Spring retainer
(B) Low clutch drum
4) Attach the ST to the low clutch drum.
ST 498437100 LOW CLUTCH PISTON
GUIDE
AT Main Case
5) Using ST1 and ST2, set the cover on the piston
and press against it, and attach the snap ring. At
this time, be careful not to bend the cover seal.
ST1 498627100
ST2 398673600
ST3 498437100
(A)
(B)
AT-00269
6) Install the dish plate, driven plate, drive plate and
retaining plate, and then secure them with a snap
ring.
(A)
(B)
AT-00270
7) Check the low clutch for operation.
(1) Remove the one-way clutch. <Ref. to 4AT-
ST 101, REMOVAL, AT Main Case.>
(2) Set the one-way clutch inner race, and apply
compressed air for checking.
AT-00271
4AT-117
AUTOMATIC TRANSMISSION
SEAT
COMPRESSOR
LOW CLUTCH PISTON
GUIDE
(A)
(B)
(A) Snap ring
(B) Low clutch drum
(C) Dish plate
(D) Low clutch piston side
(A)
(A) Apply compressed air.
(B) Low clutch drum
ST2
ST3
ST1
AT-00272
(C)
(D)
AT-02221
(B)
AT-00274