Subaru LEGACY 2006 Manual page 3334

asieps_tobira.book 53 ページ ２００９年１０月２６日 月曜日 午前９時１６分
17.Control Valve Body
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Lift-up the vehicle.
4) Clean the transmission exterior.
5) Remove the ATF drain plug to drain ATF.
CAUTION:
Immediately after the vehicle has been running
or after idling for a long time, the ATF will be
hot. Be careful not to burn yourself.
6) Tighten the ATF drain plug.
NOTE:
Use a new gasket.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
7) Remove the oil pan.
CAUTION:
Be sure to prevent the entering of dust and oth-
er foreign matters into oil pan.
8) Remove the magnet.
9) Clean the magnet.
10) Completely remove the remaining liquid gasket
on the transmission case and oil pan.
11) Disconnect the control valve connector and
front vehicle speed sensor connector.
(A)
(A) Control valve connector
(B) Front vehicle speed sensor connector
Control Valve Body
12) Remove the control valve body.
NOTE:
The control valve body is replaced as an assembly
only, because it is a non-disassembly part.
B: INSTALLATION
1) Check the control valve body for dust and other
foreign matter.
2) Install the control valve body to transmission by
equally tightening the bolts.
Tightening torque:
AT-01959
3) Connect the control valve connector.
(B)
AT-01956
5AT-53
AUTOMATIC TRANSMISSION
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(1)
(2)
(1)
(2)
(2)
(2)
(2)
(1) 58 mm (2.28 in)
(2) 65 mm (2.56 in)
(B)
(A)
(A) Control valve connector
(B) Front vehicle speed sensor connector
AT-01957
(1)
(1)
(1)
(1)
(1)
(1)
AT-01958
AT-01956