Subaru LEGACY 2006 Manual page 3709

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
5) Using new self-locking nuts, connect the rod to
the joint.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A)
(A) Stay
(B) Rod
6) Using new self-locking nuts, connect the stay to
the transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A)
(A) Stay
(B) Transmission bracket
7) Install the heat shield cover.
MT Gear Shift Lever
(B)
CS-00051
(B)
CS-00050
AT-01331
CS-36
8) Install the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-10, INSTALLA-
TION, Muffler.>
• DOHC turbo model
<Ref. to EX(H4DOTC)-12, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-13, IN-
STALLATION, Muffler.>
• DOHC 3.0 L model
<Ref. to EX(H6DO)-7, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H6DO)-9, INSTALLA-
TION, Muffler.>
9) Install the plate assembly to the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(1) Set the plate assembly to the vehicle.
(2) Temporarily tighten the bolt (A).
(3) Tighten the bolt (B).
(4) Tighten the bolt (A).
(5) Tighten the bolts (C) and (D).
(C)
(D)
10) Install the harness clamp to the plate.
11) Install the boot and insulator assembly, and se-
cure with a clamp.
12) Install the console box. <Ref. to EI-52, INSTAL-
LATION, Console Box.>
(B)
(A)
CS-00314
CS-00312