Subaru LEGACY 2006 Manual page 3343

asieps_tobira.book 49 ページ ２００９年１０月２６日 月曜日 午前９時１６分
15.Rear Vehicle Speed Sensor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, REMOVAL, Intercool-
er.>
4) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H6DO)-7, REMOVAL, Air Intake
Chamber.>
5) Disconnect the following connectors.
• Turbo model
1. Transmission harness connectors
2. Front oxygen (A/F) sensor
• Non-turbo model
(1)
(1) Front oxygen (A/F) sensor
(2) Transmission harness connectors
6) Remove the transmission harness connector
and front oxygen (A/F) sensor connector from the
stay.
Rear Vehicle Speed Sensor
7) Lift-up the vehicle.
8) Clean the transmission exterior.
9) Drain the ATF completely. <Ref. to 5AT-26, RE-
PLACEMENT, Automatic Transmission Fluid.>
10) Remove the center and rear exhaust pipes and
the muffler. (Turbo model) <Ref. to EX(H4DOTC)-
8, REMOVAL, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-12,
Pipe.> <Ref. to EX(H4DOTC)-13, REMOVAL, Muf-
fler.>
11) Remove the rear exhaust pipe and muffler.
(Non-turbo model) <Ref. to EX(H6DO)-7, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H6DO)-9,
REMOVAL, Muffler.>
12) Remove the heat shield cover.
13) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
14) Place the transmission jack under the transmis-
sion.
NOTE:
Make sure that the support plate of transmission
jack does not touch the cross.
15) Remove the transmission rear crossmember
bolt.
AT-01364
16) Lower the transmission jack.
AT-01379
NOTE:
Do not separate the transmission jack and trans-
mission.
17) Remove the oil charge pipe. <Ref. to 5AT-62,
(2)
REMOVAL, Oil Charge Pipe.>
18) Remove the ATF cooler inlet and outlet pipes.
NOTE:
When removing the outlet pipe, be careful not to
lose the ball and spring used with retaining screw.
AT-02025
5AT-49
AUTOMATIC TRANSMISSION
REMOVAL, Rear Exhaust
AT-01377