Subaru LEGACY 2006 Manual page 3388

asieps_tobira.book 36 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
22) Lift-up the vehicle. (Turbo model)
23) Remove the under cover. (Turbo model)
24) Remove the center and rear exhaust pipes and
the muffler. (Turbo model) <Ref. to EX(H4DOTC)-
8, REMOVAL, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-12, REMOVAL,
Pipe.> <Ref. to EX(H4DOTC)-13, REMOVAL, Muf-
fler.>
25) Remove the front exhaust pipe, rear exhaust
pipe and muffler. (Non-turbo model) <Ref. to
EX(H6DO)-4, REMOVAL, Front Exhaust Pipe.>
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
26) Remove the heat shield cover.
27) Remove the ATF drain plug to drain ATF.
(B)
(A) Oil pan
(B) Drain plug
28) Remove the oil charge pipe.
Automatic Transmission Assembly
29) Disconnect the connector from turbine speed
sensor 1.
Rear Exhaust
30) Remove the turbine speed sensor 1 connector
mounting bolt and rotate the sensor by 180°.
CAUTION:
Failure to follow this procedure may cause the
interference between vehicle body and sensor
while removing/installing transmission, and re-
sulting in damage.
AT-01331
(A)
31) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
32) Remove the shift select cable. <Ref. to CS-23,
REMOVAL, Select Cable.>
33) Disconnect the hose from the ATF inlet and
AT-01361
outlet pipes.
34) Remove the front crossmember support plate.
<Ref. to FS-13, REMOVAL, Front Crossmember
Support Plate.>
AT-01371
5AT-36
AT-01642
AT-01640
AT-01390