Subaru LEGACY 2006 Manual page 3895

asieps_tobira.book 29 ページ ２００９年１０月２６日 月曜日 午前９時１６分
3) Install the ST to rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
4) Insert the spline shaft until the spline portion
comes inside the side oil seal.
5) Remove ST from rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
6) Push the rear differential to insert the axle shaft
into rear differential.
7) Adjust the transmission jack, if necessary, and
insert the rear differential stud bolt into rear cross-
member bushing properly.
Rear Differential (T-type)
8) After inserting the rear differential stud bolt into
the rear crossmember bushing, lift up the transmis-
sion jack and align the rear differential to its attach-
ment position.
ST
DI-00279
9) Tighten a new self-locking nut temporarily to rear
crossmember.
DI-00280
10) Remove the band from rear differential. Lift up
the rear differential until the rear differential is sep-
arated from the transmission jack.
11) Install the rear differential front member with a
new self-locking nut.
Tightening torque:
T1: 65 N·m (6.6 kgf-m, 48 ft-lb)
T2: 110 N·m (11.2 kgf-m, 81 ft-lb)
DI-00281
DI-00393
DI-29
DIFFERENTIALS
T2
T1
DI-00283
DI-00269
DI-00284