Subaru LEGACY 2006 Manual page 3805

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5. Rear ABS Wheel Speed Sen-
sor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from the rear ABS
wheel speed sensor.
3) Remove the sensor harness bracket from the
rear arm.
Rear ABS Wheel Speed Sensor
4) Remove the rear ABS wheel speed sensor from
the rear arm.
CAUTION:
• Be careful not to damage the sensor.
• Do not apply excessive force to the sensor
harness.
ABS00389
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be careful not to damage the sensor.
Tightening torque:
Sensor:
Bracket:
NOTE:
Check the identification (mark) on the harness to
make sure there is no warpage. (RH: K5 (White),
ABS00166
LH: K6 (Yellow))
C: INSPECTION
1. ABS WHEEL SPEED SENSOR
<Ref. to ABS-14, ABS WHEEL SPEED SENSOR,
INSPECTION, Front ABS Wheel Speed Sensor.>
ABS00167
ABS00168
ABS-15
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
33 N·m (3.3 kgf-m, 24 ft-lb)
ABS
ABS00390