Subaru LEGACY 2006 Manual page 4085

asieps_tobira.book 21 ページ ２００９年１０月２６日 月曜日 午前９時１６分
10.Rear Sub Frame
A: REMOVAL
1) Separate the front exhaust pipe and rear ex-
haust pipe.
2) Remove the rear exhaust pipe and muffler.
3) Remove the rear differential.
T-type
<Ref. to DI-27, REMOVAL, Rear Differential (T-
type).>
VA-type
<Ref. to DI-44, REMOVAL, Rear Differential (VA-
type).>
4) Remove the rear stabilizer. <Ref. to RS-8, RE-
MOVAL, Rear Stabilizer.>
5) Remove the bolts which secure the rear shock
absorber to the rear arm.
6) Support the sub frame using a transmission jack.
7) Remove the front link from sub frame.
<Ref. to RS-17, REMOVAL, Front Link.>
8) Remove the rear link from the sub frame.
<Ref. to RS-18, REMOVAL, Rear Link.>
9) Remove the upper link from the sub frame.
<Ref. to RS-13, REMOVAL, Upper Link.>
10) Remove the sub frame support arm.
11) After removing the bolt, remove the sub frame
from the vehicle.
Rear Sub Frame
B: INSTALLATION
1) Install in the reverse order of removal.
2) Follow the procedure below for the rear differen-
tial installation and tightening torque.
T-type
<Ref. to DI-28, INSTALLATION, Rear Differential
(T-type).>
VA-type
<Ref. to DI-45, INSTALLATION, Rear Differential
(VA-type).>
3) Support the rear arm horizontally using a trans-
mission jack. Tighten the nuts and bolts which hold
the rear arm, front link, rear link, upper link and
shock absorber.
(1) Rear arm
(2) Transmission jack
RS-00085
Tightening torque:
<Ref. to RS-3, REAR SUSPENSION, COMPO-
NENT, General Description.>
NOTE:
Check the wheel alignment and adjust it if neces-
sary.
C: INSPECTION
Check the removed parts for wear, damage and
crack, and repair or replace them if faulty.
RS-21
REAR SUSPENSION
(1)
(2)
RS-00052