Subaru LEGACY 2006 Manual page 3292

asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分
13) Perform the stall tests with the select lever in
"D" range.
NOTE:
• Do not continue the stall test for more than 5 sec-
onds at a time (from closed throttle, fully open throt-
tle to stall speed reading). Failure to follow this
instruction will cause the engine oil and ATF to de-
teriorate and the clutch and brake to be adversely
affected.
• Be sure to cool down the engine for at least one
minute after each stall test with the select lever set
in the "P" or "N" range and with the idle speed lower
than 1,200 rpm.
• If the stall speed is higher than the specified
range, attempt to finish the stall test in as short a
time as possible, in order to prevent the automatic
transmission from sustaining damage.
Stall speed (at sea level) :
2,200 — 2,700 rpm
Stall speed (at sea level)
Below specified value
Over specified value
Stall Test
Range
• Throttle valve is not fully open
2nd gear on manual mode, R • Engine malfunction
• One-way clutch of the torque converter is slipping
• Line pressure too low
D • Low clutch slipping
• One-way clutch malfunctioning
• Line pressure too low
R • Reverse clutch slipping
• Low & reverse brake slipping
• Line pressure too low
2nd gear of manual mode • Low clutch slipping
• 2-4 brake slipping
4AT-31
AUTOMATIC TRANSMISSION
Cause