Subaru LEGACY 2006 Manual page 3726

asieps_tobira.book 52 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Remove the snap ring and synchro cone stopper
from the 5th-Rev sleeve & hub assembly.
(A) Synchro cone stopper
(B) Snap ring
5) Using the ST1, ST2 and a press, remove the ball
bearing, synchro cone and baulk ring (Rev).
NOTE:
• When replacing the sleeve & hub, replace them
as a set.
• Do not disassemble the sleeve & hub; the align-
ing position is pre-matched.
• If it is necessary to disassemble, mark the en-
gaging points on the splines beforehand.
• Do not reuse the ball bearing.
ST1 499757002 INSTALLER
ST2 498077400 SYNCHRO CONE REMOV-
ER
ST1
(A)
(A) Ball bearing
(B) Synchro cone
(C) Baulk ring
Main Shaft Assembly for Single-range
(B)
(A)
MT-00188
(B)
ST2
(C)
MT-00189
5MT-52
6) Using ST1 and ST2, remove the rest of the
parts.
NOTE:
• When replacing the sleeve & hub, replace them
as a set.
• Do not disassemble the sleeve & hub; the align-
ing position is pre-matched.
• If it is necessary to disassemble, mark the en-
gaging points on the splines beforehand.
ST1 899864100 REMOVER
ST2 899714110 REMOVER
(A)
ST2
(A) Press
ST1
MT-00190