Subaru LEGACY 2006 Manual page 3284

asieps_tobira.book 40 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
21) Attach the ST to side retainer.
ST 28399SA010 OIL SEAL PROTECTOR
ST
22) Align and insert the spline of the front drive
shaft to the splines of the differential bevel gear,
and remove the ST.
ST 28399SA010 OIL SEAL PROTECTOR
23) Insert the front drive shaft into the transmission
securely by pressing the front housing from the out-
side.
24) Install the ball joint into the housing.
25) Tighten the attachment bolts.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Automatic Transmission Assembly
26) Install the stabilizer to the crossmember.
NOTE:
• Install the bushing (on front crossmember side)
while aligning it with the paint mark on the stabiliz-
er.
• Make sure the bushing and stabilizer are marked
with the same identification colors (paint mark)
when installing.
AT-00110
27) Always tighten the rubber bushing locations
with wheels in full contact with the ground and the
vehicle at curb weight.
Tightening torque:
28) Install the shift select cable onto select lever.
<Ref. to CS-25, INSTALLATION, Select Cable.>
AT-00111
29) Install the oil charge pipe, and connect the ATF
cooler hoses to the pipe.
30) Install the propeller shaft.
<Ref. to DS-11, INSTALLATION, Propeller Shaft.>
AT-00809 31) Install the heat shield cover.
4AT-40
(1) Identification mark on stabilizer
(2) Bushing identification color
25 N·m (2.5 kgf-m, 18 ft-lb)
FS-00050
AT-01333
AT-01331