Parking Brake Cable - Subaru LEGACY 2006 Manual

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分

3. Parking Brake Cable

A: REMOVAL
1) Remove the rear seat cushion.
2) Remove the console box.
3) Remove the parking cable adjusting nut (self-
locking nut).
4) Remove the parking brake lever. <Ref. to PB-4,
REMOVAL, Parking Brake Lever.>
5) Roll up the floor mat and remove the clamps.
6) Remove the inner cable end from equalizer.
(1) Equalizer
(2) Inner cable end
7) Lift-up the vehicle, and then remove the rear
wheels.
8) Remove the parking brake cable from rear
brake. <Ref. to PB-6, REMOVAL, Parking Brake
Assembly (Rear Disc Brake).>
9) Remove the clamp from the rear brake.
10) Remove the cable clamp from the rear arm
bracket.
Parking Brake Cable
11) Remove the cable clamp from rear floor.
12) Remove the cable assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Be sure to pass the cable through the tunnel in the
cable guide.
2) Be sure to adjust the lever stroke. <Ref. to PB-4,
PB-00078
ADJUSTMENT, Parking Brake Lever.>
C: INSPECTION
Check and replace the removed cable if damaged,
rusty or faulty.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and
cracks.
4) Check the boot for damage, cracks, and corro-
sion.
PB-00008
PB-5
PARKING BRAKE
PB-00026