Subaru LEGACY 2006 Manual page 3804

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST18482AA010
ST22771AA030
D: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Use SUBARU genuine fluid, grease etc. or
equivalent. Do not mix fluid, grease, etc. of different
grades or manufacturers.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply grease onto sliding or revolving surfaces
before installation.
• Before installing O-rings or snap rings, apply suf-
ficient amount of fluid to avoid damage and defor-
mation.
• Before securing a part in a vise, place cushioning
material such as wood blocks, aluminum plate or
cloth between the part and the vise.
• Before disconnecting electrical connectors, be
sure to disconnect the negative terminal from bat-
tery.
General Description
TOOL NUMBER DESCRIPTION
18482AA010 CARTRIDGE
22771AA030 SUBARU SELECT
MONITOR KIT
CS-5
CONTROL SYSTEMS
REMARKS
Troubleshooting for electrical system
Troubleshooting for electrical system