Subaru LEGACY 2006 Manual page 3974

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
FRONT SUSPENSION
C: INSPECTION
1) Measure the play of the ball joint using the fol-
lowing procedures. Replace with a new part if the
play exceeds specification.
(1) With 686 N (70 kgf, 154 lb) loaded in direc-
tion shown in the figure, measure the length
.
2
1
(2) With 686 N (70 kgf, 154 lb) loaded in direc-
tion shown in the figure, measure the length
.
2
2
(3) Determine free play using the following for-
mula.
S = 2 – 2
2 1
(4) Replace with a new part if the play exceeds
specification.
Front ball joint
Specification for replacement S:
Less than 0.3 mm (0.012 in)
2) If the play is within specification, visually check
the dust cover.
3) Remove the ball joint and cover, and check for
wear, damage or cracks. If any damage is found,
replace the corresponding part.
4) If the dust cover is damaged, replace with a new
ball joint.
Front Ball Joint
FS-00035
FS-00036
FS-16