Subaru LEGACY 2006 Manual page 3795

asieps_tobira.book 49 ページ ２００９年１０月２６日 月曜日 午前９時１６分
B: INSTALLATION
1) Wipe off grease, oil and dust on the mating sur-
faces of transmission cases with white gasoline.
2) Install the front differential assembly.
3) Install the main shaft assembly for single-range.
Install the transmission case knock pin into the
knock pin hole of needle bearing.
4) Install the drive pinion shaft assembly.
Install the transmission case knock pin into the roll-
er bearing knock pin hole.
5) Apply liquid gasket, then join the right side and
left side of the case together.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
6) With brackets and clips as shown in the figure,
tighten the seventeen bolts.
NOTE:
Insert the bolts from the bottom and tighten the nuts
at the top.
Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.1 ft-lb)
10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
(5)
(9)
(13)
(1)
(2)
(15)
(14)
(10)
(6)
7) Tighten the ball bearing mounting bolts.
Tightening torque:
30 N·m (3.1 kgf-m, 22.1 ft-lb)
Transmission Case
(16)
(17)
(7)
(11)
(3)
(4)
(8) (12)
MT-00172
MT-00158
5MT-49
MANUAL TRANSMISSION AND DIFFERENTIAL
8) Backlash adjustment of the hypoid gear and pre-
load adjustment of the roller bearing.
NOTE:
Install the ST on drive pinion assembly.
ST 498427100 STOPPER
ST
9) Place the transmission with the left side of case
facing downward, and put ST1 on bearing cup.
10) Screw the retainer assembly from the bottom
into left case using ST2. Fit the ST3 on transmis-
sion main shaft. Shift the gear into 4th or 5th, and
turn the shaft several times. Screw in the retainer
while rotating the ST3 until a slight resistance is felt
on ST2.
This is the contact point of the hypoid gear and the
drive pinion shaft. Repeat the above sequence sev-
eral times to ensure the contact point.
ST1 399780104 WEIGHT
ST2 499787000 WRENCH ASSY
ST3 499927100 HANDLE
ST1
ST2
MT-00174
ST3
MT-00175