Subaru LEGACY 2006 Manual page 3708

asieps_tobira.book 35 ページ ２００９年１０月２６日 月曜日 午前９時１６分
13) Remove the rod from joint.
(A)
(A) Stay
(B) Rod
14) Remove the cushion rubber from the vehicle
body.
(A)
(A) Stay
(B) Cushion rubber
15) Extract the spring pin and remove the joint.
(B)
(A) Joint
(B) Spring pin
16) Lower the vehicle.
MT Gear Shift Lever
(B)
CS-00051
(B)
CS-00052
(A)
CS-00053
CS-35
17) Remove the gear shift lever.
B: INSTALLATION
1) Install the joint to the transmission and secure
with a spring pin.
2) Insert the gear shift lever from the room side.
NOTE:
Insert the rod and the stay, and then temporarily set
them onto the transmission mount.
3) Lift up the vehicle.
4) Mount the cushion rubber on the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A)
(A) Stay
(B) Cushion rubber
CONTROL SYSTEMS
CS-00315
CS-00315
(B)
CS-00052