Subaru LEGACY 2006 Manual page 3340

asieps_tobira.book 43 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Install the rear cushion rubber to the transmis-
sion.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the cross.
Tightening torque:
75 N·m (7.6 kgf-m, 55.3 ft-lb)
3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the center, rear exhaust pipes and the
muffler. (Turbo model)
<Ref. to EX(H4DOTC)-9, INSTALLATION, Center
Exhaust Pipe.> <Ref. to EX(H4DOTC)-12, IN-
STALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, INSTALLATION, Muffler.>
6) Install the front exhaust pipe, rear exhaust pipe
and muffler. (Non-turbo
EX(H6DO)-5, INSTALLATION, Front Exhaust
Pipe.> <Ref. to EX(H6DO)-7, INSTALLATION,
Rear Exhaust Pipe.> <Ref. to EX(H6DO)-9, IN-
STALLATION, Muffler.>
7) Connect the ground cable to battery.
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfied.
1. PITCHING STOPPER
Check pitching stopper for bends or damage.
Check that there are no cracks, hardening or dam-
age on rubber parts.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
Check the cross for bends or damage. Check that
there are no cracks, hardening, or damage on
cushion rubbers.
Transmission Mounting System
AT-01377
model) <Ref. to
5AT-43
AUTOMATIC TRANSMISSION