Subaru LEGACY 2006 Manual page 3719

asieps_tobira.book 43 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: DISASSEMBLY
1) Using the ST, remove the roller bearing (exten-
sion case side).
ST 498077000 REMOVER
(A)
(A) Roller bearing
2) Using ST1 and ST2, remove the roller bearing
(transfer case side).
ST1 498077000 REMOVER
ST2 899864100 REMOVER
(A)
(A) Roller bearing
Transfer Driven Gear
D: ASSEMBLY
1) Using the ST, install the roller bearing (extension
case side).
ST1 398177700
ST2 899864100
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST
MT-00143
2) Using ST, install the roller bearing (transfer case
side).
ST 499757002
ST2
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1
MT-00144
E: INSPECTION
1) Bearing
Replace the bearings in the following cases.
• In case of broken or rusty bearings
• In case of worn or damaged bearings
• When the bearings fail to turn smoothly or emit
noise in rotation after gear oil lubrication.
2) Driven gear
If the drive gear tooth surface and shaft are exces-
sively broken or damaged, replace the drive gear.
5MT-43
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
REMOVER
ST2
(A)
(A) Roller bearing
INSTALLER
ST
(A)
(A) Roller bearing
ST1
MT-00145
MT-00146