Subaru LEGACY 2006 Manual page 3392

asieps_tobira.book 40 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
26) Install the turbine speed sensor 1 and harness,
and then connect the connector.
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
27) Install the oil charge pipe.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
28) Install the heat shield cover.
29) Install the center, rear exhaust pipes and the
muffler. (Turbo model) <Ref. to EX(H4DOTC)-9,
INSTALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-12, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-13, INSTALLATION,
Muffler.>
30) Install the front exhaust pipe, rear exhaust pipe
and muffler. (Non-turbo
EX(H6DO)-5, INSTALLATION, Front Exhaust
Pipe.> <Ref. to EX(H6DO)-7, INSTALLATION,
Rear Exhaust Pipe.> <Ref. to EX(H6DO)-9, IN-
STALLATION, Muffler.>
31) Install the under cover.
32) Lower the vehicle.
Automatic Transmission Assembly
33) Install the air cleaner case.
<Ref. to IN(H4DOTC)-8, INSTALLATION, Air
Cleaner Case.>
34) Install the air intake duct.
<Ref. to IN(H4DOTC)-9, INSTALLATION, Air In-
take Duct.>
35) Connect the following connectors.
• Turbo model
AT-01736
AT-01371
• Non-turbo model
AT-01331
model) <Ref. to
5AT-40
1. Transmission harness connectors
2. Front oxygen (A/F) sensor
(1)
(1) Front oxygen (A/F) sensor
(2) Transmission harness connectors
AT-01364
AT-01379
(2)
AT-02025