Subaru LEGACY 2006 Manual page 3356

asieps_tobira.book 86 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
5) Tighten the new lock nuts using ST1, ST2 and
ST3.
Calculate the lock washer and lock nut specifica-
tions using following formula.
T2 = L2/(L1 + L2) × T1
T1: 116 N·m (11.8 kgf-m, 85.3 ft-lb)
[Required torque setting]
T2: Tightening torque
L1: ST2 length 0.072 m (2.83 in)
L2: Torque wrench length
Example:
Torque wrench length
m (in)
0.4 (15.75)
0.45 (17.72)
0.5 (19.69)
0.55 (21.65)
ST1 18667AA010 HOLDER
ST2 499787700 WRENCH
ST3 499787500 ADAPTER
NOTE:
Attach ST2 to torque wrench as straight as possi-
ble.
L2 [m (in)]
6) Measure the starting torque of the bearing. Make
sure the starting torque is within the specified
range. If the torque is not within specified range, re-
place the roller bearing.
Starting torque:
7.6 — 38.1 N (0.776 — 3.88 kgf, 1.7 — 8.6 lb)
7) Crimp the locknut in 2 locations.
Drive Pinion Shaft Assembly
8) Measure dimension "B" of the drive pinion shaft.
ST 398643600
Tightening torque
N·m (kgf-m, ft-lb)
9) Calculate the thickness "t" (mm) of the drive pin-
98 (10.0, 72)
ion shim.
100 (10.2, 73.8)
t = 6.5 ± 0.0625 – (B – A)
101 (10.3, 74.5)
10) Select three or less shims from following table.
102 (10.4, 75)
ST3
E: INSPECTION
• Make sure that all component parts are free of
ST2
scratches, holes and other faults.
• Adjust the tooth alignment. <Ref. to 5AT-87, AD-
L1 [m (in)]
JUSTMENT, Drive Pinion Shaft Assembly.>
ST1
AT-00202
AT-00203
5AT-86
GAUGE
B
Drive pinion shim
Part number Thickness mm (in)
31451AA180 0.150 (0.0059)
31451AA190 0.175 (0.0069)
31451AA200 0.200 (0.0079)
31451AA210 0.225 (0.0089)
31451AA220 0.250 (0.0098)
31451AA230 0.275 (0.0108)
AT-00204