Subaru LEGACY 2006 Manual page 3335

asieps_tobira.book 54 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
4) Attach the magnet at the specified position of the
oil pan.
5) Apply liquid gasket to the oil pan.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
6) Install the oil pan by equally tightening the bolts.
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
7) Pour ATF through the oil charge pipe.
Specified and recommended fluid:
<Ref. to 5AT-2, SPECIFICATION, General De-
scription.>
Capacity:
Fill with the same amount of ATF as drained.
8) Check the ATF level.
<Ref. to 5AT-26, Automatic Transmission Fluid.>
9) Perform Clear Memory 2 operation. <Ref. to
5AT(diag)-18, CLEAR MEMORY MODE, OPERA-
TION, Subaru Select Monitor.>
10) Perform the inspection with driving the vehicle
at the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from the transmission body, etc.
• Occurrence of noise caused by interference etc.
NOTE:
If excessive shift shock is felt, execute advance op-
eration of learning control. <Ref. to 5AT(diag)-22,
PROCEDURE, Learning Control.>
Control Valve Body
C: INSPECTION
Check each parts for holes, damages or other for-
eign matters.
AT-01959
AT-01955
5AT-54