Subaru LEGACY 2006 Manual page 3885

asieps_tobira.book 66 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
4) Insert the drive pinion into the differential carrier,
and install the preselected bearing preload adjust-
ing collar and washer.
(A)
(B)
(C)
(A) Drive pinion
(B) Bearing preload adjusting collar
(C) Bearing preload adjusting washer
(D) Differential carrier
5) Set ST and differential carrier to the press and
install the front bearing cone.
ST 399780104 WEIGHT
NOTE:
Set the carrier to the press until the companion
flange is installed.
6) Insert the collar, then install the pilot bearing.
(A) Pilot bearing
(B) Collar
Rear Differential (VA-type)
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until the oil seal end comes 1 mm (0.04
in) inward from end of carrier.
• Apply grease to the oil seal lips.
ST 499277200
(D)
DI-00382
8) Press-fit the companion flange with ST.
NOTE:
Be careful not to damage the bearing.
ST 899874100
ST
DI-00383
9) Apply seal material on the drive pinion shaft
thread and new self-locking nut seat.
SEAL MATERIAL
THREE BOND 1324 (Part No. 004403042) or
equivalent
(A)
(B)
DI-00389
DI-66
INSTALLER
ST
DI-00089
INSTALLER
ST
DI-00384
ST
DI-00372